How to Boot into Recovery Mode for Yealink Phones

How to Boot into Recovery Mode for Yealink Phones

How to Boot into Recovery Mode for Newer Yealink Models

Notes
Supported Models: SIP-T58W, SIP-T42U, SIP-T43U, SIP-T46U, SIP-T48U, SIP-T57W, SIP-T54W, SIP-T53W, SIP-T53, SIP-T53C, CP965, CP925, and VP59. Your Model May Not Be Listed
  1. Locate and press the “Speaker” button on your Yealink.

  2. Disconnect the power supply cable from the A/C outlet or disconnect the PoE connection from the Internet Port, but do not release the button.
  3. Reconnect the power cable or PoE Connection while still holding “Speaker.”
  4. Check if the “Recovery” mode confirmation screen shows.

  5. Press “1” on the dial pad to access the “Recovery” mode.
  6. If the phone did not enter recovery mode, try the guide for going into recovery mode on older models. 

How to Boot into Recovery Mode for Older Yealink Models

  1. First, long-press the “Redial” button on your Yealink unit.
  2. Disconnect the power supply cable from the A/C outlet or disconnect the PoE connection from the Internet Port, but do not release the button.
  3. Keep holding “Redial” while reconnecting the power cord.
  4. Check if the “Recovery” mode confirmation screen shows.

  5. Press the button on the keypad that says “Yes” on-screen.

    • Related Articles

    • How to Factory Reset a Yealink Phone

      How to Factory Reset a Yealink Phone Note: This should not be your first step in troubleshooting. Hold the "OK" key on the Yealink Phone for 10-15 seconds until you see the following message. Using the softkey select "OK" and wait for the phone to ...

    • Yealink T5 Series-Phones Call Forwarding User Guide

      You can configure your phone to forward incoming calls to another party at all times. This is called Static Forwarding. There are three types of static forwarding: Always Forward - incoming calls are immediately forwarded. Busy Forward - incoming ...

    • 3CX: What are "Softphone Mode" and "CTI Mode"?

      The 3CX app can be used in either “Softphone Mode” or “CTI Mode”. Softphone Mode – make and receive calls on your computer without using a desk phone. CTI Mode – a supported desk phone is required for the app to manage your calls from the desktop.

    • How to Transfer a Call on Yealink Desk Phones

      OneCloud features various ways to move calls around, including Attended Transfer, Blind (Unattended) Transfer, Voicemail Transfer, Hold, Park, and more. Blind Transfer Note: A Blind Transfer immediately goes directly to the recipient. Press the ...

    • Transfer a Call on Yealink Desk Phones | OneCloud Support Portal

      OneCloud features various ways to move calls around, including Attended Transfer, Blind (Unattended) Transfer, Voicemail Transfer, Hold, Park, and more. Blind Transfer Note: A Blind Transfer immediately goes directly to the recipient. Press the ...