How to Request a Welcome Email | OneCloud Support Portal
Instructions
A new user can request a welcome email by following the below steps:
- Navigate to myonecloud.com with a supported web browser.
- Select "Are you a new user?" at the bottom of the login page.
- Provide your email address that is associated with the OneCloud account
Optionally: You can provide your extension number if you already know it.
- You will receive an email with your login username, extension number, and associated phone number. Selecting "Complete Setup" will allow you to change your password and voicemail pin for your account.
Related Articles
How to Send Welcome Emails to End Users | OneCloud Support Portal
Accessing the Portal You will first need to complete setting up your account using the Welcome Email sent to you by either the onsite installer or TelWare support team. Once set up, you can access your account by navigating to Myonecloud.com. Home ...OneCloud Overview | OneCloud Support Portal
Accessing the Portal You will first need to complete setting up your account using the Welcome Email sent to you by either the onsite installer or TelWare support team. Once set up, you can access your account by navigating to Myonecloud.com. Home ...Analytics Wallboard Guide | OneCloud Support Portal
Welcome to the call center analytics user guide. This article has been designed to help familiarize you with the basic layout, as well as guide you through creating an analytics board and some advanced features. Accessing the Analytics Board Note: To ...OneCloud v43 Release Notes | OneCloud Support Portal
New Features Added Poly Edge E devices to Button Config and NDP. Added Grandstream GRP2670 to Button Config and NDP. Toggle Timeframe now allows for the selection of a remote user and timeframe allowing any phone to monitor another user's timeframe ...OneCloud v44.1 Release Notes | OneCloud Support Portal
OneCloud V44.1 Release Notes New Features Added Snom M500 Button Builder and general support. Now, call blocking rules for the domain user will be applied to any user configured for allow/block. Currently, this only applies to "Users". Increase ...